Combos
Hold one control, then press or turn another, to do something else. Holding a key on its own counts too. Combos and multi-step actions share the pad's small memory.
All profiles
Brightness
Also on the pad itself: hold the knob and turn it (factory setting).
Animation speed
For breathe and rainbow.
Board
3 keys and a knob
Wildpad runs many CH552 pads. Tell it which one this is, so each key does what you set.
Choosing a board starts over with factory settings for it. Save a backup below first if you want to keep yours.
Knob
Reverse direction
Swap turning right and left.
Clicks per full turn
Only used to draw the knob on this page. Count the clicks in one full turn.
Half-step knob
Turn on if every click counts twice or only every second click counts.
Timing
Hold time
How long a key must be held for its long-press action.
Tap length
How long a key press lasts when the pad taps a key for you (knob clicks, released combos). Raise it if a program misses taps.
Switcher hold after turning
When a knob turn keeps a modifier held (like Alt for Alt+Tab), it is let go this long after the last click.
Debounce
Raise it if one press is sometimes counted twice.
Profiles and startup
Profiles
How many profiles you use. The pad's memory is small: every profile you don't use leaves 22 more bytes for combos and multi-step actions.
Profile after plugging in
The pad starts in this profile.
Backup and reset
The file works with the command-line tool too (wildpad.py import).
Firmware
A pad that still runs its factory firmware: install Wildpad step by step.
The pad switches to its update mode by itself; the browser asks once to use Wildpad: pick it. No driver is needed. If the pad doesn't answer, plug it in while holding key 1 and press Update firmware: that starts the chip's own bootloader (USB Module), which on Windows needs the WinUSB driver once: run Zadig while it's connected, choose USB Module, install WinUSB. Without the browser: flash.bat from the Wildpad download.